Alico AP24 Bedienerhandbuch

1 Wireless Network Equipment Optima Series: Models AP24, BR24, CP24 Configuration Type: 24-AE-19F Optima Series: Models AP58, BR58, CP58 Configura

10 Setting Up the IP Address 1. Click on the “IP” button on the left column and select address. 2. Click on the “+” button 3. Setup your netwo

11 Checking the Wireless Setup 1. Click on the “Wireless” button on the left column of the WinBox window 2. Then double click on the “wlan1” line

12 Support • This is a short guide to get started with the AP24 • The AP24 has a very rich routing and firewall capabilities • You are welcome to

2 Notices FCC Notice: Part 15 Notice: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (

3 Scope: This equipment is intended to be installed by professional trained installers familiar with the appropriate FCC Regulations and Local Build

4 WNE Wiring Diagram The wireless network equipment is powered by a 48 VDC Power over Ethernet power supply/injector module. The following steps sho

5 Cable Feed-through Assembly Step 1: Use a Cat 5/6 cable with a open RJ45 connector without a boot. • Do not tighten compression gasket until y

6 Starting Winbox Using the MAC Address Note: In order to connect using the MAC address your PC must be on different subnet than the default AP24 IP

7 Starting Winbox Using IP Address 1. If your PC is setup on the same subnet as the default AP24 IP address 192.168.0.239 then you must use the IP a

8 Looking at Interfaces 1. Click on the “Interfaces”’ button on the left column 2. Double click on the “ether1” interface to see the illustrated

9 Bridging the ether1 and wlan1 Ports 1. On the Bridge window click on the “Ports” tab 2. Double click on the “ether1” line 3. Select “bridge1” o